![]() Retrieving file: /extlinux/./socfpga_arria10_socdk_sdmmc.dtb Loadmk Load device generated with mkimageįor loadmk operating on FIT format uImage address must includeĨ289256 bytes read in 408 ms (19.4 MiB/s)Īppend: root=/dev/mmcblk0p2 rw rootwait earlyprintk console=ttyS0,115200n8 Loadb Load device from bitstream buffer (Xilinx only) WDT: Started with servicing (10s timeout) įPGA: Start to program peripheral/full bitstream. Type the escape character followed by C to get back, For a complete list of overlays for available hardware, please visit the project list.Īfter editing config.txt, reboot for changes to take $ reboot System kermit -l /dev/ttyACM0 -b 115200 -cĮscape character: Ctrl-\ (ASCII 28, FS): enabled Many ADI hardware overlays are included with Kuiper Linux, for evaluation boards and reference designs. # Uncomment this to enable the lirc-rpi module ![]() At this point, the appropriate device tree overlays can be included, for example, add the following line to enable the ADX元45 3-axis SPI accelerometer, noting that the lirc-rpi lines are shown for reference, and any line beginning with “#” is ignored: Before editing, it is a good idea to make a backup of the original file, just in case something goes wrong (which it won't, but still…) Open a terminal and enter the following command (noting that $” is the prompt, and does not need to be $ sudo cp /boot/config.txt $ sudo mousepad /boot/config.txt The ADI Kuiper Linux desktop should appear. Using the Raspberry Pi itself also avoids problems with USB encryption, often present on company computers.Ĭonnect a keyboard, mouse, and monitor to the Raspberry Pi and connect power. Any text editor can be used, including the Mousepad editor that is included with Kuiper Linux. The most straightforward way to do this for Raspberry Pi is to edit the config.txt file, which is located in the boot partition. ![]() The system will need to be configured according to what devices are connected to the Raspberry Pi.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |